– 3.37 –
OffsetA, OffsetB :
Setting Description
-40.00 - Generally the origin will set the following position.
+40.00mm However, the position of the origin may differ depending on the application software. In this case,
it can be corrected.
When the origin becomes out of the effective cutting area, "ERR37 MARK ORG" will be appeared
on the display. In the cause, please write the position of registration marks on the seat on a center
side of the seat.
MARK FORM :
Setting Description
TYPE1
Select either one of the following types of the registration mark.
TYPE2
Mark: TYPE1 Mark: TYPE2
Plus A direction Plus A direction
Plus B direction Plus B direction
Mark: TYPE1 Mark: TYPE2
To Next Page
Loading...
