MIMAKI CG-130SRIII - Output the Received Data by the ASCII Code [ASCII DUMP]

Other Useful Functions
1
1
3
Useful Function
5
6
3-51
Output the received data by the ASCII code [ASCII DUMP]
This function makes the host computer send data to the plotter, and makes the plotter plot the data in ASCII
format.
The dump can be executed through the interface to which the host computer is connected.
1
Replace the tool with “pen” ( P.2-6) .
2
Press the key in the local mode.
3
Press the jog key or to select [ASCII
DUMP].
4
Press the key.
• You cannot check the dumped contents directly on the computer.
• To cancel the dump function, press the key to return to the local mode and execute DATA
CLEAR ( P.3-48) ,
• If executing a dump, perform sheet detection by using rear set (press ( ). ( P.2-15)
FUNCTION
ENTER/HOLD
REMOTE