3-62
11
Press the jog key or to select [DHCP] .
12
Press the key.
• Press to set ON/ OFF.
• When it is ON, the IP address given by the DHCP server is used.
13
Press the key.
14
Press the jog key or to select [AutoIP] .
15
Press the key.
• Press to set ON/ OFF.
• When it is ON, the IP address is determined by the AutoIP
protocol. However, DHCP is ON, DHCP has priority.
16
Press the key.
17
Press the jog key or to select the set values.
• Both of DHCP and AutoIP is OFF, you can set IP Address/ Default Gateway/ DNS Address/ Sub Net
Mask. For other than above, proceed to the Step 21.
18
Press the key.
19
Press the jog key to select the set values.
20
Press the key to confirm the value.
21
Press the key several times for terminating this function.
• To reflect network settings, turn OFF the power once and turn ON again.
To Next Page
Loading...
