2-10
Select the tool condition
Before cutting (plotting), select the tool condition depending on the sheet and the tool type to be used.
1
Press the key in LOCAL mode.
2
Press the key to select a tool condition to be used.
• Each time you press the key, the tool condition is
switched as follows.
3
Cutting (plotting). ( P.2-22)
Set the Tool Conditions
Set the condition to cut or to plot with a pen.
Setting contents of cutting condition (CUT1 to 7) : Cut speed (SPEED)/ cut pressure (PRESS)/ OFFSET
value/ Half cut
Setting contents of plotting condition (PEN) : Plotting speed (SPEED)/ pen pressure (PRESS)
1
Press the key in LOCAL mode.
2
Press the key to select a tool condition to be
set.
3
Press to set the cutting (plotting) speed.
• Set the moving speed of the tool for cutting or pen plotting.
• Setting values : 1 to 10cm/s (settable by 1cm/s step)
15 to 70cm/s(settable by 5cm/s step)
4
Press to move the cursor to cutting (plotting)
pressure (PRESS).
To Next Page
Loading...
