2-11
1
2
Basic Operations
4
5
6
Setting the tool conditions
5
Press to set the cutting (plotting) pressure.
• Set the pressure that the tool presses the sheet for cutting or pen
plotting.
• Setting values : 10 to 20g (settable by 2g step)
25 to 100g (settable by 5g step)
110 to 500g (settable by 10g step)
6
Press to move the cursor to OFFSET.
7
Press to set the offset value .
• When you set the cutting condition (CUT1 to 7), set the distance
between the center of the cutter holder and the blade tip.
• Setting values : 0 to 250 (0.00 to 2.50mm)
(settable by 0.05mm step)
8
Press to move the cursor to half cut ON/OFF.
9
Press to set ON/OFF .
• When you perform half cut, select ON and proceed to the Step 10.
• When you do not want to set AUTO CUT, select "OFF" and proceed to
Step 16.
10
Press to move the cursor to pressure setting of
left part (not to be cut).
11
Press to set pressure .
• Set the pressure of the left part (not to be cut) when performing half cut.
• Setting values : 0 to 300g (settable by 5g step)
12
Press key to move the cursor to the setting of
length to be left.
• When the cutting (plotting) pressure setting is completed, proceed to the setting of the
OFFSET value. When you set the plotting condition (PEN), you cannot set the OFFSET
value and half cut. Proceed to the Step 16.
• The maximum pressure at selecting PEN is 150g.
• Nothing is displayed on the LCD if "0" is specified.
To Next Page
Loading...
