2-12
Setting the tool conditions
13
Press to move the cursor to the setting of
length to be left.
• Set the length to be left not to be cut when performing half cut.
• Setting values : 1 to 5mm (settable by 0.1mm step)
14
Press to move the cursor to the setting of cut
length.
15
Press to set the cut length.
• Set the length to be cut when performing half cut.
• Setting values : 5 to 150 mm
(5 to 20mm: 1mm step, 20 to 150mm: 5mm step)
16
Press the key to register the set contents.
• Return to the local mode.
• The set value is retained even when the power is turned "OFF".
To Next Page
Loading...
