2-18
4
Pull out the sheet for maintaining.
(1) Pull the sheet tightly and take up the slack.
(2) Check that the sheet is set without slacks and then move
down the clamp lever to the front.
• When the power is on, the absorbing fan is turned on to absorb
the roll sheet.
• If the power is not on, the absorbing fan is not turned on.
Therefore, pressing the sheet with your left hand so as not to
be deformed, raise the clamp lever.
5
Press the jog key or to select [ROLL].
• “Sheet detection” ( P.2-14)
• : In the case the sheet is loaded from the rear
• : In the case the sheet is loaded from the front
6
Start detecting the sheet.
• After displaying the sheet width, the plotter performs the dummy
cutting operation ( P.3-69) .
7
Perform [FEED] and pull out the sheet of the length you use. ( P.3-47)
• When you press the key, the screen to select the number of pinch rollers is
displayed before sheet detection. After selecting the pinch roller, sheet detection is
performed.
• The number of pinch rollers set here has priority over the one selected from [SET UP] -
PINCH ROLL.] menu.
• Before you use the roll sheet, previously pull out the sheet of the length you use to make enough
room. By feeding out the sheet, you can verify if there is any sheet misalignment or not.
To Next Page
Loading...
