3-10
Perform Multiple Cuttings
• If the multiple sheet cutting is executed immediately after cutting in the remote mode, cutting (plotting)
will be overlapped. To avoid this trouble, be sure to set the new origin.
• While the plotter is executing the multiple sheet cutting, it ignores data sent from the computer.
• To send two or more pieces of data from the computer to the plotter, the data has to be sent while
providing an interval of 5 seconds or more between any two pieces of data. If two pieces of data are
sent from the computer to the plotter within 5 seconds, the two pieces of data will be subjected to the
multiple sheet cutting. (
This time can be changed in the close time setting. P.3-53)
• During setting of the two-point axis alignment, if the origin updated inside the plotter fails to fall within
the available cutting area, the plotter will not perform cutting for the data.
• The plotter performs cutting for divided cutting data by the specified number of sheets without dividing
the data. If any error is displayed, refer to [Chapter 4] .
• If there is the origin renewal command in cutting data, you cannot perform [No. COPIES].
• When you use FineCut, the default value of Origin Renewal is “ON”. If you perform [No. COPIES],
uncheck the checkbox. (Refer to FineCut OPERATION MANUAL Chapter5 “Setting Head Position
after Plotting”)
• When the origin mode is set to "Center", the cutting result may not be as intended. When cutting
multiple sheets, we recommend setting the origin mode to "Bottom right".
When the origin is set to center, the data size range is the
diagonal size of the minimum cut range area to the maximum
data range (shown by red dotted lines); therefore, data as
shown in the illustration will create wide margins.
When the origin is set to center, and if you are using an
application such as FineCut, the data is output to the minus
position coordinate from the origin, considering the position of
the origin. Data is copied with minus offset (shown with blue-
dotted line); therefore by renewing the origin at the time of
cutting multiple sheets, the media is cut at the position away
from the position of the origin.
The first sheet is overlapped and cut, but when the origin is set
to center, you need to cut multiple sheets without renewing the
origin.
To Next Page
Loading...
