MIMAKI CG-130SRIII - Precautions in Inputting Data with Registration Marks

3-12
Precautions in inputting data with registration marks
There are some limitations on preparing data with registration marks.
In order to make full use of this function, read the following instructions carefully and prepare data with
registration marks properly.
Size of the registration marks
The registration mark length shall be about more
than ten times the line width.
In addition, for the length of a side of the
registration mark against the data, refer to ”The
size of, and the distance between, registration
marks” ( P.3-14).
The area where registration marks and designs can be arranged
• The TP1 starting position must be 20 mm or more away from the leading edge of the sheet.
• The TP2 end position must be 45 mm or more away from the tail end of the sheet.
Mark Form :
Type 1
Mark Form :
Type 2
• The registration mark described here is intended to detect the sheet inclination and the lengths along
the A and B axes. It is not a mark for trimming.
0.5~2.0mm
4~40mm
The area where plotting
(cutting) is permitted
Available cutting area when
the expands is set to OFF.
Available cutting area when
the expands is set to ON.
Pinch roller
45 mm and more
A : Between 50 and 3000 mm
20 mm and more
B : 50 mm and more
The area where plotting
(cutting) is permitted
Available cutting area when
the expands is set to OFF.
Available cutting area when
the expands is set to ON.
Pinch roller
30
mm + or mor
e
45 mm + or more
Mark length
2
20 mm + or more
Mark length
2
A : Between 50 and 3000 mm
B : 50 mm and more
Keep the marks away
from the pinch rollers.