MIMAKI CG-130SRIII - Page 68

3-18
Setting Items
Setting the Number of Registration Mark Detection
The higher the number of detected points, the higher the cutting accuracy.
DIST.REVI
Select “OFF” when using FineCut.
Size
• Select “1pt” when using FineCut.
Setting Description
OFF Select this setting for cutting a normal sheet, not for cutting the outline.
1pt Detects the TP1. Sets only the origin.
2pt A
Detects the two registration marks TP1 and TP2. Performs the skew compensation and
the scale compensation in the sheet feeding direction.
2pt B
Detects the two registration marks TP1 and TP3. Performs the skew correction and the
scale compensation in the width direction.
3pt
Detects the three registration marks TP1, TP2 and TP3. Performs the skew compensation
and the scale compensation in the sheet feeding and the width direction.
4pt
Detects the four registration marks TP1, TP2, TP3 and TP4. Performs the skew
compensation, the scale compensation in both directions, and the trapezium
compensation.
Setting Description
OFF The plotter will not perform any scale compensation.
BEFOR
With this setting, enter the scale compensation values and the trapezium compensation
*1
value before executing the registration mark detection.
( P.3-21 , P.3-24)
Since the distance between registration marks is entered beforehand, rapid movement is
expected when detecting.
*1. The diameter difference between the grit rollers may cause a significant difference in the sheet feeding distance between the
right side and the left side. The trapezium compensation function correct this difference in sheet feeding between the right
side and the left side.
AFTER
With this setting, enter the scale compensation values and the trapezium compensation
value
*1
after executing the registration mark detection.
( P.3-21 , P.3-24)
Since there is an understanding of the distance between marks, setting values can be
input rapidly. The AFTER setting will take less time than the BEFORE setting.
Setting Description
4~40mm
Set the length of one side of the registration mark.
When the printed mark's horizontal and vertical lengths differ from
each other, set the same value as the shorter length.
Length of one side