3-19
1
1
3
Useful Function
5
6
Cut Out Data with Registration Mark
Offset A, Offset B
MARK FORM
COPIES A ( UP ), COPIES B ( LEFT )
SPD LIMIT
Setting Description
± 40.00mm
Generally the origin will be set at the position shown below.
However, depending on your application and the work to be cut, the cutting position may be
misaligned to the same direction. In this case, the location of the origin can be corrected.
If the origin is located out of the available cutting area, “ERR37 MARK ORG” will
be displayed. In this case, write the registration marks in the area closer to the center of
the sheet.
Setting Description
TYPE1
TYPE2
Select either one of the following types of registration marks.
Setting Description
1~9999
(COPIES A)
1~99
(COPIES B)
Effective when the same pattern is multi-printed at regular intervals.
Cuts automatically the preset number of sheets while detecting registration marks
consecutively based on the first data.
For leaf sheets (cut sheets), the value of [COPIES A] is used as
the number of copies.
When the number of copies can be set on the application
software, like on the supplied FineCut, set the value to [1].
3x3 copies
Setting Description
0~60cm/s
Set a speed limit for rapid moving in continuous copying.
During rapid moving, mark detection may not be performed correctly if a slippery sheet is
used. In such a case, set a speed limit. If no speed limit is required, set the value to “0”.
To Next Page
Loading...
