3-22
Detecting procedure ( [DIST.REVI.] Setting value is “BEFOR”)
1
Measure the lengths A and B on the data to be
output.
2
Place TP1 at a location shown at right.
• If it is impossible to place the registration mark TP1 at the
location shown in the sketch, follow the procedure for “Semi-
automatic registration mark detection”.
3
You must take care to tighten the sheet, and move
down the clamp lever to the front.
• Then the pinch rollers will retain the sheet.
4
Press the key.
• The scale compensation display appears after detecting only the
sheet width. (The right figure shows the 4-point detection display
as an example.)
• In case [ROLL. SELECT] is set [ON] ( P.3-18), select the
number of pinch roller to use.
5
Set with the jog key or .
• Press the key. And the plotter moves to the next
scale compensation setting.
• If [MARK DETECT] is set to [2ptA], the display for inputting the B length
will not appear.
• If [MARK DETECT] is set to [1pt], the scale compensation setting
display will not appear but the origin point will be displayed. (Step 7)
6
Press the key after completing the
settings.
• The registration mark detection will be started.
• In case the plotter cannot detect any registration marks, it displays
“Error C36 in the registration mark detection” on the display. Set
the sheet again.
• Be sure to set the sheet in the rear.
To Next Page
Loading...
