3-24
4
Press the key after completing the
settings.
• Set the origin.
• The display will show the available cutting area and then return to
local mode.
Semi-automatic detection of registration marks
When TP1 cannot be located at the position where it can be
detected full-automatically or when no registration mark can
be detected full-automatically, perform registration mark
detection semiautomatically.
Detecting procedure ( [DIST.REVI.] Setting value is “BEFOR”)
1
Load the sheet Load the sheet and move down the
clamp lever to the front.
• Then the pinch rollers will retain the sheet.
2
Perform the sheet detection by pressing the jog key
or . (Set the sheet in the rear.)
• In case [ROLL. SELECT] is set [ON] ( P.3-18), select the
number of pinch roller to use.
• Once the sheet is detected, the display indicates that the plotter is
waiting for registration mark detection operation.
• When the sheet is set in the front, the positions of the TP1 to
TP4 are viewed inverted as shown at right.
To Next Page
Loading...
