3-29
1
1
3
Useful Function
5
6
Cut Out Data with Registration Mark
Confirm the following when failed in cutting correctly.
Check the sensor for the registration mark detection
Prepare the sheet on which the registration mark is printed.
1
Make sure that the plotter is in local mode.
2
Enter the jog mode by pressing the jog key or
3
Move the tip of the pen to the registration mark detection position by pressing the
appropriate ones of the jog keys and .
• Perform registration mark detection at a position 1mm or more away from the registration mark.
4
Press the key to terminate the jog mode.
• The plotter returns to the local mode.
5
Press the key.
• If you move the head and sheet manually, you cannot perform the right response check. Be sure to
perform it via the following operations.
•
For conditions of already printed registration mark, refer to “Precautions in inputting data with
registration marks” ( P.3-12).
• The setting values are kept in memory even when the power is turned off.
• The settings performed here for shape of the registration mark and length of the registration mark are
reflected in the settings of “MARK DETECT”.
(P.3-12)
• The detection speed selected here will be used in the registration mark detection operations that are
executed from here on.
• The pointer offset value selected by this operation is not initialized by SETUP RESET operation.
•
Set the buzzer sound to “ON”. (P.3-77) The registration mark detection sound is not made if the
buzzer sound is set to OFF.
To Next Page
Loading...
