3-37
1
1
3
Useful Function
5
6
Switch the cutting (plotting) direction
This function sets the location of origin and direction of the axes of coordinates according to the application
software to be used. (ROTATION function)
The Setting of ROTATION.
1
Press the key in the local mode.
2
Press the jog key or to select [SET UP] .
3
Press the key.
4
Press the jog key or to select [ROTATION] .
5
Press the key.
6
Press the jog key or to select Setting.
• ON : Performs the rotation of the axes of coordinates and the
movement of the origin at the same time.
• OFF : Does not perform the rotation.
7
Press the key.
8
Press the key twice for terminating this function.
• The setting values are kept in memory even when the power is turned off.
• Confirm that any data to be cut is not saved in the receiving buffer. If you change the set values, the
contents of the receiving buffer are cleared completely.
• Rotation cannot be enabled if the register mark detection function is enabled.
First turn off the register mark function before enabling rotation. ( P.3-16)
• The cut area settings are returned to the default settings if the rotation settings are changed.
Rotating function : OFF
Origin
Rotating function : ON
Origin
After the sheet detection, the
carriage will stop at the origin.
To Next Page
Loading...
