5-4
Cutter blade
Replacing the cutter blade
If the cutter blade is chipped or blunt, replace it with a new one. (Accessorry parts number)
New cutter blades (low-pressure blade set for PVC sheets: Model SPB-0030) are available from your
distributor or MIMAKI's sales office.
1
Loosen the lock nut, and pull the
adjusting knob out of the holder.
2
Insert the cutter blade into the
adjusting knob using tweezers.
3
Tighten the lock nut.
• The cutter blade is sharp. Keep your fingers away from the blade.
• Do not shake or swing the cutter holder; otherwise, the blade may come off, which is
dangerous.
• Keep the cutter blade out of reach of children. Dispose of the used cutter blade in
compliance with the applicable regulations.
To Next Page
Loading...
