MIMAKI CG-60SR - Operation Workflow and Tool Setup

2-2
Operation flow
1
Installing a tool
2
Mount the Manual Cutter.
3
Turning the power on
4
Setting the tool
conditions
5
Loading a sheet of media
6
Test cutting (plotting)
7
Cutting (plotting)
See "Installing a tool" ( P.2-3)
See "Mount the Manual Cutter."
( P.2-7)
See "Turning the power on"
( P.2-9)
See "Setting the tool conditions"
( P.2-10)
See "Loading a sheet of media"
( P.2-13)
See "Test cutting (plotting)"
( P.2-20)
See "Cutting (plotting)" ( P.2-21)
8
Turning the power off
See "Turning the power off"
( P.2-24)