MIMAKI CG-60SR - Installing a Tool; Using a Cutter

2-3
2
Basic Operations
Installing a tool
For this device, you can use the following tools.
Cutter : Select this to cut the image printed on a sheet and to create the cut letters with
the cutting sheet.
Pen (rollerball) : Select this to “trial-write” for confirming how to actually cut.
Pouncing Pin (option) : Select this to sketch the cutting line.
Using a cutter
How to install a cutter blade
1
Take out the cutter holder.
2
Loosen the lock nut, and pull the
adjusting knob out of the holder.
3
Insert the cutter blade into the
adjusting knob using tweezers.
4
Tighten the lock nut.
• Don’t touch the cutter blade with your fingers.
->Sharp cutter edge may cause to injure you.
• After setting the cutter, don’t shake the tool.
->The cutter edge may pop out and may cause to injure you.
Lock nut
Adjusting knob