Loading a sheet of media
2-19
2
Basic Operations
5
Pull out the sheet for maintaining.
(1) Pull the sheet tightly and take up the slack.
(2) Make sure that the sheet is loaded without slack,
then raise the clamp lever.
• When the power is on, the absorbing fan is turned
on to absorb the roll sheet.
• If the power is not on, the absorbing fan is not
turned on. Therefore, pressing the sheet with your
left hand so as not to be deformed, raise the
clamp lever.
6
Release the stopper for roll-placing
table.
7
Install the sheet support to the roll table
as shown in illustration.
8
Press the jog key or to select [ROLL].
• "Sheet detection" ( P.2-14)
• ：In the case the sheet is loaded from the rear
：In the case the sheet is loaded from the front
9
Start detecting the sheet.
• After displaying the sheet width, the plotter
performs the dummy cutting operation ( P.3-
69) .
10
Press the key to pull out the sheet of the length you want to
use.
• Before you use the roll sheet, previously pull out the sheet of the length you use to make
enough room. By feeding out the sheet, you can verify if there is any sheet misalignment or
not.
To Next Page
Loading...
