3-31
Cut Out Data with Registration Mark
3
Useful Function
6
Press the jog key or to select
“ON”.
7
Press the key.
8
Press the jog key or to select
the scan width.
• Set values : 3 to 30cm
9
Press the key.
10
Press the jog key or to select
the search range.
• Set values : 5 to 50cm
11
Press the key.
12
When you want to terminate this procedure,
press the key twice.
• If it is not recognized as a registration mark or there is no response even if the function scans
the area set for search, the message indicating the search failure will be displayed in a certain
time.
Then, it will return to the original point and the mode will move to the normal semi-automatic
registration mark detection mode.
To Next Page
Loading...
