3-37
Cut Out Data with Registration Mark
3
Useful Function
4
Select [MARK sensor] by pressing the
jog key or .
5
Press the key.
6
Select [LEVEL ADJ] by pressing the jog
key or .
7
Press the key.
8
This plotter automatically performs the
sensitivity adjustment.
9
Press the key after making
certain that the display is showing a
number steadily.
• The display may not become so steady that it keeps showing only one fixed number. In
that case, press the key when the value of the high-order digit on the display is
fixed.
• The plotter will return to the local mode after registering the adjusted value.
• The value registered in the [LEVEL ADJ] is not initialized even by executing the [SETUP
RESET].（
P.3-70）
To Next Page
Loading...
