MIMAKI CG-60SR - Alignment of Mark Sensor

3-38
Alignment of MARK SENSOR
The offset value of the cutter and the mark sensor can be adjusted.
Set the sheet on which the register mark is printed.
1
Install a cutter in the tool holder.
2
Confirm that the plotter is in the local
mode.
3
Press the key.
4
Select [MARK SENSOR] by pressing
the jog key or , and press the
key.
5
Select [SENSOR OFS] by pressing the
jog key or .
6
Press the key.
• After detecting the register mark (one point), five
additional lines are cut every 0.2 mm on the
center line and on both sides of the center line of
the detected register mark.
CUT1 20 050 0 . 30
DATA CLEAR <ENT >
FUNCTION
SENSOR CHK <en t >
ENTER/HOLD
SENSOR OFS <e n t >
A=0 . 0 B=0 . 0
ENTER/HOLD
A direction
B direction
Misaligned by +0.2mm
from the center line of the
register mark ( ) in
the A and the B direction.