MIMAKI CG-60SR - Page 87

Cut Out Data with Registration Mark
3-39
3
Useful Function
7
Enter the corrected value (mm) by
pressing the jog keys for the A
direction, or the for the B direc-
tion.
• If misaligned by +0.2 mm, enter “-0.2”.
8
Press the key.
• The plotter will return to the local mode after
registering the compensation value.
• The setting values are kept in memory even when the power is turned off.
• The sensor offset value selected by this operation is not initialized by SETUP RESET
operation.
A= - 0 . 2 B= - 0 . 2
CUT1 20 050 0 . 30
ENTER/HOLD