Configuration and function
1-8
Clamp
The clamp pressure can be changed in two levels using the clamp pressure lever. Select the higher or lower
level of the clamp pressure that matches the sheet to be used.
Sheet sensor
The sheet sensor detects the presence of the sheet and the sheet length.
There is one for each position before and after the platen.
• Be sure to set the clamps of the left and right to the same mode for use. If the clamps’ modes are
different, it may cause the sheet misalignment.
• After setting the position of the pinch roller, set the clamp pressure.
Clamp pressure Application
High mode
For cutting a PVC sheet.
When a heavy-weight sheet of media (70 kg or 81g/m2 or more)
is used.
Low mode
When the impression of the pinch rollers on the sheet of media
are to be minimized.
• The sheet may drift depending on the sheet typ
feed length, or the sheet width.
To Next Page
Loading...
