MIMAKI CG-60SRIII - CHAPTER 2: Basic Operations; Installing a Tool; Turning the Power On; Setting Tool Conditions

This chapter describes the procedures and settings ranging from
tool installation to cutting (plotting) operation.
Installing a tool..................................................................... 2-3
Using a cutter ..............................................................................2-3
How to Install a Ballpoint Pen .....................................................2-6
Turning the power on .......................................................... 2-8
Setting the tool conditions.................................................. 2-9
Kinds of the Tool Conditions .......................................................2-9
Select the tool condition ............................................................2-10
Set the Tool Conditions .............................................................2-10
Setting a sheet ................................................................... 2-14
Setting a leaf sheet (cut sheet) .................................................2-17
How to Place the Roll Sheet (CG-60SRIII) ...............................2-18
How to Place the Roll Sheet (CG-100SRIII/CG-130SRIII) ........2-20
Test cutting (plotting) ........................................................ 2-23
Cutting (plotting)................................................................ 2-25
Setting the origin .......................................................................2-25
Start cutting (plotting) ................................................................2-26
Cut off the Sheet (Manual Cutting) ...........................................2-27
Turning the power off ........................................................ 2-28
CHAPTER 2
Basic Operations