2-8
Turning the power on
1
Press the “ | ” side of the power switch.
• When the plotter is turned on, it will enter the first operation
mode, which are followed by the subsequent modes. Refer to
P.1-11 for the operation modes.
• The POWER indicator lamp lights up in blue.
• The machine performs its initial operation.
2
After the origin detecting operation, the tool condition
currently selected is displayed.
• Before turning the power on, check that the pinch rollers have been raised.
• Be sure to turn on the host computer before turning on the plotter. If this order is not correctly
followed, the plotter can malfunction.
• Once the power is turned off, wait at least five seconds before turning the power on again.
To Next Page
Loading...
