2-24
Start cutting (plotting)
1
After completion of setting the origin, press the
key.
• The display changes to REMOTE.
2
Send the data to the plotter.
• On receiving the data, the plotter performs cutting (plotting) while
displaying the remaining amount of the data.
• Upon completion of cutting (plotting), the display changes as
shown at right.
Bringing the cutting (plotting) to a halt
To temporarily stop the plotter during cutting (plotting), press the key once. Another press of the key
will make the plotter resume cutting (plotting).
• In case the sheet has slipped off the plotter during cutting operation, turn off the power immediately;
otherwise, the main unit may be damaged.
• The LCD will show the following error message if you try to execute any function that can initiate
some action during temporary suspension or any operation that can affect the command coordinate
system.
• If the error message appears, let the plotter complete the cutting for the remaining portion of the data
or discontinue the cutting by executing data clearing ( P.3-48).
To Next Page
Loading...
