3-6
Set the distance compensation
When you cut the long data, the cut length may have difference depending on the sheet thickness. In addition,
depending on the difference of the grid roller diameter, the moving amount of right and left of the sheet may
have difference. Correct these differences.
You can select the distance correction from eight types (No. 1 to No. 8).
Find compensation value
Compensation value = Measured value of the OFF line - Input reference length
• Actual measured value of OFF line:999.0 mm
• Entered standard length:1000 mm
• 999.0 - 1000 = -1.0 mm / (correction value)
Setting value :
• Standard value
A direction: 500, 1000, 1500, 2000, 2500 (mm)
B direction(CG-60SRIII): 200, 400, 600 (mm)
B direction(CG-100SRIII/130SRIII): 200, 400, 600, 800, 1000 (mm)
• Correction value:
A direction: Standard length ± 5% (0.1mm step)
B direction: Standard length ± 5% (0.1mm step)
• Plotting offset: 0 to 300mm
Setting procedures
1
Mount the sheet. ( P.2-13)
• Set the sheet to plot the distance correction adjusting pattern.
2
Press the key in LOCAL mode.
3
Press to select [DIST.COMP.].
To Next Page
Loading...
