3-42
8
Press the jog key or to select [DIV.LENG] .
• Setting value
In “mm” : 50cm to 500 cm (in increments of 50cm)
In “inch” : 1 to *** feet (in increments of 1 ft.)
• When it exceeds the set value, the machine cuts it at that position by dividing it.
9
Press the key.
10
Press the jog key or to select [CROSS
CUT] .
• Setting value
In “mm” : 0mm to 50mm (in increments of 1cm)
In “inch” : 1 to *** feet (in increments of 1 ft.)
• The machine cuts by overlapping it by the set value.
11
Press the key to perform setting, and press the key twice to
terminate this function.
Reset the setting for DIVISION CUT.
• The setting values are kept in memory even when the power is turned off.
• During execution of division cutting, the plotter ignores any other data sent from the host computer.
• In any of the following cases, the plotter cannot perform division cutting.
The data size is larger than the receiver buffer capacity.
An origin change command is contained in the cutting data.
A two-point compensation value has been set.
The registration mark detection is being performed.
The plotter cuts the test data stored in it.
Follow the Steps 1 to 5
of “Set the Y direction
(width direction)
DIVISION cut”
Press the jog key
to select
“OFF.”
Press the
key.
Press the
key twice.
To Next Page
Loading...
