© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.20 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > PEN NO. ASSIGN
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
4.2.20 PEN NO. ASSIGN
Outline
Assigns the pen number specified in the command (SPn: n=No.) to Pen No. in the plot.
The tool type is applied to the pen number when the application of the tool type at the initial condition of this machine
to the pen number of command is not changeable by the application software.
Work procedures
1. Select [#ADJUST(CUT)] -> [PEN NO. ASSIGN].
2. The current setting is indicated by the [ENTER] key.
3. Select the pen number specified in the command.
[]/[]: Cursor move (Pen No. change)
* In the left figure, it is “SP4;” since the cursor position is
“n=4”.
4. Select a pen in the plotter.
[]/[]: Pen change
[ENTER]: Fix/Register
5. Register the set value by pressing the [ENTER] key.
The setting change is not required as far as the application or the dedicated system is not too old.
This setting is effective when the MGL-IIc command is selected.
#ADJUST(CUT)
PEN NO. ASSIGN
#PEN NO. ASSIGN
SP1; n=1
2345678
#PEN NO. ASSIGN
SP4; n=1234
5678
SP4; n=XXX1XXXX
Command pen No.
Plotter pen No.
Plotter pen No. Indication Function
1 CUT1 Cutter blade compensation
2 PEN Plotting
3 CUT2 Cutter blade compensation
4 CUT3 Cutter blade compensation
5 CUT4 Cutter blade compensation
6 CUT5 Cutter blade compensation
7 CUT6 Cutter blade compensation
8 CUT7 Cutter blade compensation
To Next Page
Loading...
