MIMAKI CJV150-107 - Chapter 5: Washing the Ink Discharge Passage; Chapter 5: Machine Storage Procedures; When Not Used for a Long Time

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.21 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > PEN STROKE
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
Rev.
4.2.21 PEN STROKE
 Outline
The pen stroke information of machine is read out, confirmed and moved to optional height.
 Work procedures
1. Remove the media.
Set the cutter holder that is removed the cutter blade from the
cutter Assy. in the Tool Holder.
Arrange the pinch rollers at the center and ends of both sides
then make the rollers lowered.
2. Select [#ADJUST(CUT)] -> [PEN STROKE].
3. The head moves to the right end.
4. Check or detect the pen stroke value.
[]: Detecting (to the procedure 5)
[]: Checking (to the procedure 6)
*Invalid if no registered.
5. Measure the pen stroke automatically, and then register them.
6. Check the stroke value that has already been registered in the
machine.
[ENTER]: Fix
7. End with the [END] key.
Pinch roller pressure is “middle” for all pinch rollers.
#ADJUST(CUT)
PEN STROKE [ENT]
#PEN STROKE
<LOOK CHECK>
STROKE = 4.85mm
After the completion, check the stroke value in
“LOOK”. Adjust the head height if the stroke value
is other than 5 ± 0.2 mm.
#PEN STROKE
<LOOK CHECK>
#PEN STROKE
STROKE= 4.85mm
 Be sure that the pen stroke is within 5.0 ± 0.2 mm.
 An error is indicated when the stroke range (the differ-
ence between MIN and MAX) exceeds 1 mm.
[ABNORMAL STROKE] (End with the [END] key.)