MIMAKI CJV150-107 - 4.2.22 400 mm SQUARE

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.22 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > 400 mm SQUARE
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
Rev.
4.2.22 400 mm SQUARE
 Outline
A square of 400 mm is drawn, and then the parameters are compensated to adjust the travel of each axis and the
mechanical error of the squareness between two axes.
The compensation values are registered in the system parameters. (No. 0, 1 and 2)
 Work procedures
1. Set the accessory ball-point pen (marketed item) in the Tool
holder.
2. Select [#ADJUST(CUT)] -> [$400 mm SQUARE].
3. Press the [] key to draw the pattern.
* No pattern is drawn unless drawing space is available on the
sheet.
4. Measure lengths of the A and B axis and the right-angle
compensation value on the patterns drawn.
End by the [END] key if no difference is observed on the
measured values.
If any difference, clear the parameters once, and then draw the
patterns again and measure. (Start from the procedure 5.)
5. Press [ENTER] twice, then press [] to clear the system
parameter values (No.0, 1, 2).
6. Draw the patterns again then measure.
7. Input the compensation value of the A-direction.
[]/[]: Compensation value input
(-6.0~ 6.0: 0.1 mm unit)
[ENTER]/ []: Register/To next
400mm
400mm
Distance
compensation value
Right-angle
compensation value
Right-angle
compensation value
Reference line
#ADJUST(CUT)
400mmSQUARE[ENT]
Pattern drawing
Pattern measurement
Any difference?
No
Yes
End by [END]
Parameters cleared?
No
Yes
After parameter
clear, draw
patterns again.
(Procedure 5)
Compensate parameters
(Procedure 7)
#400mmSQUARE
dA=0.1
dB=0.0
The calculation of compensation value is shown in the
following.
Compensation value (mm) =
Measured value – 400 mm
(0.1mm unit)