MIMAKI CJV150-107 - Chapter 5: Replacing Waste Ink Tank Before Confirmation; Chapter 5: Replacing the Cutter Blade

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.1 P.2
4.3.1 Adjustment of the Carriage Slant
1
2
3
4
5
6
7
8
6. Put the thickness gauge between the head mask plate and the
platen.(Refer to left figure.)
Fix the carriage by pushing it down and tightening adjusting
screws (x4).
 Back and forth slant (Vertical-tilt) adjustment
7. Remove the Sensor BKT. (screw x1.)
8. Loosen the head lock screw (x2) by half revolution.
Thickness gauge x4
Adjusting screw
x4
Orange line
Yellow line
Sensor BKT
Head lock screw x2
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Carriage Slant
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.