MIMAKI CJV150-107 - Chapter 5: Replacing and Adjusting the Cutter Blade; Adjusting the Cutter Blade; Replacing Cutters Other Than Supplied

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.1 P.3
4.3.1 Adjustment of the Carriage Slant
1
2
3
4
5
6
7
8
9. Loosen the screws of the Adjustment lever (2 screws of both
sides).
10. Put the thickness gauge between the head mask plate and the
platen, and then adjust by rotating the adjust lever so that the
height of right and left is 1.8mm±0.05mm.(Refer to left figure.)
Rotate to downward, carriage is risen.
Rotate to upward, carriage is lowered.
11. When adjustment has been completed, fully tighten the head
lock screws (x2).
12. Tighten the screw of the adjustment lever (x2).
13. Recheck the height for right and left and back/ forth slant.
1) If the height for right and left has changed, perform the
procedures in the Step 8 to 10.
2) If the back/ forth slant are found, perform the procedures
in the Step 11 and 12.
14. Attach the Sensor BKT and Cutter Assy.
Lower cable of the Sensor BKT is yellow.
Adjustment lever x2
1.8mm±0.05mm
thickness gauge
Adjust this while checking all range height so that
there is no difference between the carriage base for
right and left.
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the Carriage Slant
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.