MIMAKI CJV150-107 - Power Does Not Turn On; Machine Does Not Start Printing; Media Jamming or Soiling Issues

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.5 P.1
1
2
3
4
5
6
7
8
R.1.0
4.3.5 Adjustment of the JAM Sensor Height
 Outline
Adjust the height of the JAM sensor.
 Procedure
1. Move the carriage onto the platen.
2. Move the Head height adjust lever to the lowest position.
3. Move the clamp lever downward.
4. Loosen the fixing screw (x2) by one revolution.
5. Put thickness gauge between the jam sensor and the platen, and
align the height.
Height adjusting range: 1.7 -1.8mm
6. Tighten the fixing screw.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Be sure to perform adjustment with the clamp lever
down. In addition, the head initialization height shall
be L range setting.
thickness gauge
Fixing screw
JAM sensor
Head height adjust
lever
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjustment of the JAM Sensor Height
Model CJV150/300 Issued 2014.09.15 Revised F/W ver. 1.00 Remark
1.0
Rev.