MIMAKI CJV150-107 - 4.3.10 Adjusting the Location of Mark Sensor

© 2014 MIMAKI ENGINEERING CO.,LTD.
4.3.10 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Adjustment Items > Mechanical Adjustment > Adjusting the Location of Mark Sensor
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver. Remark
1.0
Rev.
4.3.10 Adjusting the Location of Mark Sensor
 Function
Adjust the distance between the mark sensor (photo sensor) and the platen to the specified value.
 Procedure
1. From the back side of the printer, loosen the screws (x2) that
hold the T sensor BKT.
 Set the pressure of all the clamps to Middle, and make the adjustment on the right station side.
 This adjustment is to be made mechanically without using any [#ADJUST] item. After completion of
this adjustment, however, make the adjustments of [PHOTO SENSOR] among the [#ADJUST] items.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
2.8 mm
+0.2/-0.0
Mark sensor
T Sensor BKT
Loosen
When no sheet is set: the plotter waits for input of a
compensation value without plotting.