© 2014 MIMAKI ENGINEERING CO.,LTD.
4.2.7 P.1
1
2
3
4
5
6
7
8
R.1.0
4.2.7 ADJUST WIPER
Outline
Adjusts the location for the wiper. Adjusted value is saved in the system parameter.
Adjustment procedure
1. Select [#ADJUST] - [ADJUST WIPER].
2. Check and adjust the position of the wire blade tip and the head
side.
Visually check that it moves approximately 1 mm from the head
side.
[]/ []: Left/ right direction (Y direction) shifts the
head.
[ENTER]: Finalizes (To Next)
[END]: End
3. Confirm and adjust the center position of the head and the wiper
blade.
[]/ []: Forward/ backward direction (X direction)
shifts the head.
[ENTER]: Finalizes (To Next)
[END]: End
FUNCTION
#ADJUST [ENT]
#ADJUST
ADJUST WIPER [ENT]
About 1mm
Head 1
Wiper
Adjust by moving to Y direction
#ADJUST WIPER
WIPER POS.(Y) = 2.0
The adjustment value is also reflected in the wiping
start position for head 2. (For only 300 series)
Head 1
Wiper
Center position
Adjust by moving to X direction
#ADJUST WIPER
WIPER POS.(H1) = 2.0
#ADJUST WIPER
WIPER POS.(H2) = 2.0
H1:Adjustment for head 1
H2:Adjustment for head 2 (available for 300 series)
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > ADJUST WIPER
Model
CJV150/300
Issued
2014.09.15
Revised F/W ver.
1.00
Remark
1.0
To Next Page
Loading...
