This chapter
describes procedures and setting methods for ink and media preparation, and printing.
Workflow of printing ......................................2-2
Turning the Power ON/OFF ..........................2-3
Turning the Power ON ................................ 2-3
Turning the Power OFF ............................... 2-3
Setting a Media .............................................2-4
Adjusting the Head Height .......................... 2-4
Adjusting the Position of the Pinch Roller
According to the State of a Media ............... 2-5
Maximum Print Area/Cut Area .................. 2-10
Notes When Using media Holder .............. 2-10
Setting a roll media ................................... 2-11
Setting the pinch roller pressure ............... 2-13
Take-up device .......................................... 2-14
Setting leaf media ..................................... 2-15
Changing the printing origin ...................... 2-16
Preparing for the Heaters ............................2-16
Changing the Temperature Settings for
the Heaters ................................................ 2-16
Test Printing ................................................2-17
Test Printing .............................................. 2-17
Perform test printing with the normal test
pattern ....................................................... 2-18
Perform test printing with the test pattern
for checking white ink ................................ 2-18
Head Cleaning ............................................2-19
About head cleaning ................................. 2-19
Perform head cleaning depending on the
test printing result ...................................... 2-19
Setting of Media Correction .........................2-19
Setting of Media Correction ......................2-19
If the Positions of Dots Shift... .....................2-20
Printing Data ...............................................2-20
Starting a Printing Operation .....................2-20
Stopping a Printing Operation ....................2-21
Deleting Received Data (Data Clear) ........2-21
Cutting a media ...........................................2-21
Workflow of cutting ......................................2-22
Installing Tools ............................................2-23
When a Cutter Is Used ..............................2-23
How to Install a Ballpoint Pen ....................2-24
Setting the cutting conditions ......................2-26
About the Cut Conditions ...........................2-26
Select the tool condition .............................2-26
Set the Cut Conditions ...............................2-27
Test Cutting .................................................2-28
Cutting Data ................................................2-28
Setting the origin ........................................2-28
Start cutting ................................................2-28
Stopping a Cutting Operation
(Data Clear) ...............................................2-29
Removing the Cutter Unit Temporarily ......2-29
Cutting a media ...........................................2-29
Chapter 2
Basic Operations
To Next Page
Loading...
