2-26
Chapter 2 Basic Operation
Setting the cutting
conditions
You can register the cutting speed and the pressure
depending on the sheet or the tool type to be used.
(Cut condition)
About the Cut Conditions
Items you can set here
About Selecting Cutting Condition
1
Press the key to display “TOOL” in
LOCAL.
2
Press to display the cut condition.
• The three items shown in the following screen are
not displayed unless the half-cut is set to ON.
About Half Cutting
You can cut on the dotted line, not to cut sheet out.
(Half cut)
When you set half cut to valid (ON), you can use the half
cut function.
Select the tool condition
Before cutting (plotting), select the tool condition
depending on the sheet and the tool type to be used.
1
Press the key in LOCAL to display
the “TOOL” menu.
2
Press the (TOOL).
3
Press the key.
4
Press to select a tool condition
to be used.
• Each time you press [][], the tool condition is
switched as follows.
5
Cutting. ( P.2-22)
Tool
condition
You can select the cutting condition No.(1 to 7) or
plotting condition (PEN).
Cut speed
Setting of the speed of cutting.
Cut press
Setting of the pressure required for cutting. (g)
Offset
*1
*1. You cannot set this when "PEN" is selected in the tool condition,
Setting of the distance from the center of the cutter
holder to the cutter blade.
Half cut
*2
*2. The three items in the lower level are available when the half-cut is
set to ON.
Setting of enabling (ON)/disabling (OFF) the half-
cut function.
Half cut
press
Setting of the pressure of left part. (g)
H-leng
Setting of the length to be left (not to be cut). (mm)
C-leng
Setting of the length to be cut. (mm)
• The illustration above is the image. The shape of
cut surface differs depending on the cutting
conditions.
To Next Page
Loading...
