Chapter 4 Cutting Funcion
4-4
Example of cause of wrong detection 1
There is a line outside the registration marks
Example of cause of wrong detection 2
The distance between registration marks (TP2 and TP1 or
TP4 and TP2) is smaller than the mark length (for Type 2)
The size of, and the distance between,
registration marks
The size (Y) of a registration mark suited for the distance
(X) between the marks is as shown below. If the mark size
(Y) is too small relative to the distance (X), the marks may
not be detected correctly. Be sure to prepare the
registration marks with an appropriate size.
(mm)
Distance between registration marks
for copied designs
For Type 1 registration marks, the distance between the
marks must be not shorter than two times the mark length
and not longer than 1000 mm. For Type 2 registration
marks, the distance between the marks must be not
shorter than the mark length and not longer than 1000
mm.
Recommended size of the area defined
with a set of four registration marks
It is recommended that the size of the area defined with a
set of four registration marks is in the range of A4 size
(210 mm x 297 mm) to A3 size (297 mm x 420 mm). If you
follow this recommendation, you can minimize wasteful
spaces and arrange the designs efficiently.
X 200 max. 500 max. 1000 max. 2000 max. 2001 min
B 5 to 40 8 to 40 15 to 40 25 to 40 35 to 40
To Next Page
Loading...
