4-5
Chapter 4 Cutting Funcion
4
2
2
In case of perform printing a
registration mark continuously
When perform printing a registration mark continuously,
set the one side of the registration marksize to 8mm. In
case 8mm or shorter registration mark recognized
continuously, may cause the glitches on the main unit.
Color of mark
The mark must be printed in black against the white
background.
The registration mark will not be detected correctly if the
background is not white or the mark is not black.
Mark blurred
If the mark is blurred, a wrong mark origin can be
detected, thus resulting in deviated cutting.
Notes for the combined operation of
print & cut
When performing combined operation of print & cut with
RasterLink 6 or later, be careful to the following items:
(1) When performing combined operation of print &
cut with the attached application software to this
device (RasaterLink 6 Ver.3.0 or later / FineCut
8.4.1 or later), the following set contents will
follow the instruction of software side. Note that
the contents set in this device will be invalid.
• Register mark size
• Register mark shape
(2) The combined operation of print & cut without a
register mark is not performed under the
following conditions:
• Print & cut using the take-up device
• Other than the above conditions, there is a
possibility of the cutting line being misaligned
depending on the printing data size. Therefore, it
is also recommended to perform the operation
with the data which has register marks for
combined operation of print & cut.
To Next Page
Loading...
