Chapter 4 Cutting Funcion
4-6
Setting of Detecting the Registration
Marks
When you want to cut the data with registration marks,
you must set the following without fail.
1
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press to select the “MARK
DETECT”, and press the key.
3
Press to select the setting item,
and press the key.
• Refer to “The setting items of detecting the
registration marks”( P.4-6).
4
Press to select the setting value,
and press the key.
• Set value : Standard, high speed, High quality
5
Press the key several times to
end the setting.
The setting items of detecting the
registration marks
There are the following seven setting items for registration
mark detection.
(1) MARK DETECT
(2) MARK TYPE
Select either one of the following types of registration
marks.
(3) MARK SIZE
Set the length of one side of the
registration mark.
• You can set the register mark detection without
pressing [FUNC1] (MENU) from LOCAL.
(1) Press the [SEL] key in LOCAL to display
"TEST CUT".
(2) Press [FUNC2] (TEST CUT)
(3) Press the [ENTER] key
• After this, go to step 3 of "Setting of Detecting the
Registration Marks".
Setting Description
ON/OFF
The registration marks can be detected if this is
set to ON.
• Use the copy function of cutting software, in the
case of continuous cut, select the register mark of
Zero margin, and you will be able to place no
margin between the register marks.
By eliminating the margin between the register
marks to cut efficiently, recommend to use register
mark shaped “Zero Margin”.
Setting Description
Type 1
Type 2
Zero margin
Setting Description
5 to 40mm
When the printed mark's horizontal and vertical
lengths differ from each other, set the same
value as the shorter length.
To Next Page
Loading...
