MIMAKI CJV150-107 - Chapter 4: Print & Cut with Registration Marks; TP OFFSET Adjustment; Chapter 4: Setting the Scale Adjust

4-19
Chapter 4 Cutting Funcion
4
2
2
For Print & Cut with registration marks
1
Set the machine to "REMOTE" status.
2
Set the print conditions (profile, cut conditions) of the job that you want to print using RasterLink6.
3
Click [print & cut Origin adjust] in the [Cut edit] tab of RasterLink6.
4
Select "Add registration mark".
• Click [OK] to print the adjustment pattern.
5
When the pattern is printed, press (ADJUST) and select "TP OFFSET".
• When the media is fed, peal the cut part of the pattern, and check the adjustment values
(The actual pattern has registration marks.)
6
Enter the adjustment values
• When you press the [ENTER] key, the media return, and the operation is completed.
Setting the Scale Adjust
When printing and cutting without registration marks, adjustment is performed if the misalignment in the scanning direction
occurs between the left and right edges of the media.
When you perform scale adjustment, adjustment is performed automatically.
1
Set a media ( P.2-4)
• Set the sheet to print the registration mark.
2
Press the key, and press the
(ADJUST)
in LOCAL.
• ADJUST MENU will be displayed.
3
Press to select the “SCALE ADJUST”, and press the key.
4
Press to select the resolution, and press the key.
5
Press the key several times to end the setting.
X enlarged
Y enlarged
Enter the value of the position that has the
least misalignment between top and bottom
The example here shows that -4 has the least
misalignment, so enter “-0.40”.
Enter the value of the position that has the
least misalignment between right and left
The example here shows that 2 has the least
misalignment, so enter “0.20”.