5-7
5
2
Chapter 5 Maintenance
7
Clean the cap rubber.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance solution for
maintenance.
Wipe off so that maintenance solution for
maintenance will not remain.
8
Press the key after the cleaning.
9
Close the front cover then press the
key.
• After its initial operation, the machine returns to
step1.
Washing the Head Nozzle
1
Press the
(MENU)
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press to select the “STATION”,
and press the key.
3
Press to select “NOZZLE WASH”,
and press the key.
• The carriage will move onto the platen.
4
Clean the wiper and the bracket, and press
the key.
(1) Open the right maintenance cover then pull
out it by holding projections at both ends of
the wiper.
(2) Clean the wiper and bracket with a clean
stick dipped in maintenance washing liquid
for maintenance. (SPC-0369: for solvent ink /
SPC-0137: for sublimation dye ink)
• Wipe off so that maintenance washing liquid
for maintenance will not remain.
(3) Insert it in the original position by holding the
projections at both ends of the wiper.
5
Clean the cap rubber , and press the
key.
• Wipe off the ink sticking to the cap rubber with a
clean stick dipped in maintenance washing liquid
for maintenance.
• Wipe off so that maintenance washing liquid for
maintenance will not remain.
• At this time, the discharge passage is cleaned
automatically.
6
Fill up the cap with cleaning solution for
maintenance．
7
Close the front cover, and press the
key.
To Next Page
Loading...
