MIMAKI CJV150-130 - Cleaning the Ink Head and the Area Around It

5-10
Chapter 5 Maintenance
12
Open the front cover.
13
Fill up the cap with cleaning solution for
maintenance．
• If the cleaning solution cartridge is not usable,
suck maintenance solution into a dropper and fill
up the cap with it. Fill up the cap with
maintenance solution on the verge of overflow
from the cap.
14
Close the front cover and press the
key.
• After its initial operation, the machine returns to
step2.
Cleaning the Ink Head
and the Area around It
Because the ink head employs a very precise
mechanism, due care needs to be taken when it is
cleaned.
Using a clean stick, etc., rub off gelatinous ink or dust that
may stick to the lower part of the slider and the area
around the ink head.In doing so, never rub the nozzles of
the head.
1
Press the
(MENU)
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press the key twice to select the
“CARRIAGE OUT”.
3
Press to select “HEAD
MAINTENANCE”, and press the
key.
• The carriage will move to the left end of this
machine.
4
Open the maintenance cover.
Tools required for cleaning
• Clean stick (SPC-0527) • Gloves
• Goggles
• Be sure to wear the attached goggles and gloves
when cleaning the area around the ink
head.Otherwise, you may get ink in your eyes.
• The ink contains organic solvent.If you get the ink
on your skin or in your eyes, wash it away with
plenty of water immediately.
Head maintenance
cover
Maintenance cover