MIMAKI CJV150-130 - 4.2.24 PHOTO SENSOR

5-12
Chapter 5 Maintenance
5
Register the Nozzle number that needs
NOZZLE RECOVERY and press
key.
(1) Select the registration number from 1 to 10
by pressing [][] key and press the
[ENTER] key.
(2) Register the nozzle number that needs
recovery by pressing [][] key and press
the [ENTER] key.
6
Press the key several times to
end the setting.
Reset the set value
1
Press the
(MENU)
key in LOCAL.
• MAINTENANCE MENU will be displayed.
2
Press to select “NOZZLE
RECOVERY”, and press the key.
3
Press to select “RESET”, and
press the key.
4
Press and
(PAGE>)
(<<)
to selet theNozzle line that
need reset, and press the key.
• A reset confirmation message will be displayed.
5
Press the key.
6
Press the key several times to
end the setting.
Automatic Mainte-
nance Function
To use this machine comfortably, you can set various
maintenances to be performed automatically.
Here, set performing intervals of various automatic
maintenances.
You can prevent troubles such as ink clogging by
performing automatic maintenance periodically (automatic
maintenance function).
For the auto maintenance functions, the following items
can be set:
• Up to 10 nozzles can be registered per 1 nozzle
line.
• Even if you use this function, time required for
drawing does not change.
• When printing has been done with the lowest
path, nozzle recovery is not reflected.
Moreover, depending on the conditions, there are
cases where only 20 to 120 nozzles are enabled
at both head ends (front and rear). Perform test
printing to confirm.
• When you use white ink, print on the clear film to
check.
Recovery nozzle No. or OFF
Registration number : 1 to 10
Nozzle missing
No.184
Nozzle number
Nozzle missing No.16
Nozzle missing
No.128
Registration
number
Recovery
Nozzle No.
State
1 16 Target for nozzle recovery
2 128 Target for nozzle recovery
3 184 Target for nozzle recovery
4 OFF No registration
5 OFF No registration
Example of nozzle to be recovered
• When you perform maintenance manually, after
manual maintenance is completed and when time
set with the automatic maintenance function has
passed, maintenance starts automatically.
Function name Descriptions
REFRESH
The interval between each refreshing
operation is set.
CLEANING (Interval)
The interval between each cleaning operation
is set.
CLEANING ( Type ) The cleaning type is set.
• If the “Check waste ink” warning message is
displayed, the operation set in the auto
maintenance function is not carried out. Perform
the operations of P.5-16 “Replace the waste ink
tank with another” if required.
• When the power switch on the front of the
machine is turned off, check the waste ink tank.