2-11
2
2
2
2
2
Chapter 2 Basic Operation
Setting a roll media
Set a roll media to the roll media hanger located on the
back of this machine.
1
Move the roll holder located in the back of
the device to the direction of the middle of
the device.
• Loosen the roll holder fixing screw and move it.
2
Check the clamp lever is lowered.
3
Move the roll holder to the roll setting
position.
• Check the media size and the position to set the
media, referring to the section applicable to your
machine ( P.2-18 to P.2-21).
4
Tighten the roll holder fixing screw.
• Check the Step 2 to 3 again.
5
Set the left end of the core of the roll media
on the left roll holder.
• Push the roll media onto the roll holder until the
roll core is all the way seated.
6
Loosen the screw of the right side roll
holder then insert the holder into the core
of the roll media.
7
Raise the clamp lever in the rear of this
machine.
8
Insert the roll media in this machine.
• The roll media can be smoothly inserted by
slanting the media.
(1) Pull the media out of the roll to the head of
the platen.
(2) Insert the media between the platen and the
pinch roller.
• Pull the media out of the roll so that the
media can be grasped from the front of the
machine.
(3) Push down the clamp lever from the back of
this machine.
• The media is held.
• Take care not to drop the media on a foot or so
when the media is set. It may cause an injury due
to the media.
Roll Holder Side
(The back of this machine)
Setting position of 2inch tube
Setting position of 3inch tube
Adjust the basic position of the roll holder
so that it is placed between the guide
marks of the pinch rollers.
• Set the pinch roller units so that the media can be
held at equally spaced intervals. If the pinch rollers
cannot be set at equally spaced intervals, start
over from Step 3.
• Ensure there is a dead space of 5 mm or above at
each end of the media. ( P.2-10)
To Next Page
Loading...
