MIMAKI CJV150-130 - Setting the Pinch Roller Pressure

2-13
2
2
2
2
2
Chapter 2 Basic Operation
16
Secure the media on the take-up device.
(P.2-14)
(1) Feed the media up to the core of the roll media of
the take-up device by pressing the [  ] key.
(2) Fix the middle of the media with adhesive tape.
(3) In the same manner, fix the left side and right side
of the media.
• Make sure that the there is no slack or wrinkle on the
media in such condition that the roll media is pulled
to right and left evenly, and stick the tape.
Setting the pinch roller pressure
After setting the media in place, set the pressure of the pinch
rollers that retain the media.
Be sure to set a pressure value that is appropriate for the media.
With an inappropriate pinch roller pressure value, the media
could skew during printing or cutting, or the pinch rollers could
remain on the media after pinching.
You can set the following items in pinch roller pressure settings:
1
Press the (PR) key in LOCAL.
2
Press to select setting item, and
press the key.
3
Press , to select the setting
value.
4
Press the key.
5
Press , to end the setting.
• If you want to switch to another setting
immediately, press [<].
Entering the media remaining amount
When [MEDIA RESIDUAL] of the machine setup is “ON”
(
P.3-13), the screen for entering media remaining
amount is displayed after detecting the media width.
1
Display the screen for entering media
remaining amount.
2
Press to enter the media
remaining amount.
3
Press the key.
Setting of the manual media width
setting
When [MEDIA DETECT] of the machine setup is
“MANUAL” ( P.3-13), set the media width in the
following method.
1
Display the screen for entering the right
edge position of the media.
2
Press to enter the right edge
position of the media.
3
Press the key.
• Next, the screen to enter the left edge position of
the media is displayed.
4
Press to enter the media the left
edge position of the media.
5
Press the key.
Item Setting value Outline
NUMBER
FOR USE
1 ～ 7
Set the number of the pinch rollers you
are using.
This number differs depending on the
model you are using.
PRINT
LOW/ MID/
HIGH
Set the pinch roller pressure for
printing.
CUT: ENDS
LOW/ MID/
HIGH
Set the pressure of the edge pinch
rollers (left and right edges) used when
cutting the media.
CUT: INNER
OFF/ LOW/
MID/ HIGH
Set the pressure of the pinch rollers
except for the edge pinch rollers used
when cutting the media.
CHANGE
EXECUTION
PRINT/ CUT
Switch between the setting for printing
and cutting.