2-14
Chapter 2 Basic Operation
About the media residual print
When [MEDIA RESIDUAL] of the maintenance function is
“ON” ( P.3-13), You can print a list of print the current
date and media remaining.
1
In Local, Press .
• It enters into the origin setting mode.
2
Press the key.
• Appear the confirmation screen of media
remaining print.
3
Press the key.
• Media residual print starts.
Take-up device
With the switch of the narrow take-up device, select the
take-up direction of the media or others.
Setting the torque limiter
The take-up device is provided with a torque limiter.
The take-up torque can be adjusted with the torque limiter.
(The torque limiter is set to "media" at delivery.)
If the tension is too strong to use a thin media of media,
lower the take-up torque with the torque limiter.
Clockwise turn :
Increases torque (a heavy and thicker media such as
tarpaulin or the like)
Counterclockwise turn :
Decreases torque (For light media)
When Not Using Taking-up Device
• Be careful not to set the position beyond the media
range, as it may cause printing or cutting outside
the media.
Direction
selector
switch
UP
(REVERSE)
The take-up device winds the media
with the printed side facing in.
DOWN
(FORWARD)
The take-up device winds the media
with the printed side facing out.
ON/OFF button
Turns the winding motion on/off.
(When you press the button and
operate the take-up device, the device
keeps taking up the media until you
press the button again.
*1
)
*1. You can also change the setting so that the taking-up operation only
lasts while the ON/OFF button is being pressed. For details, refer to
“Setting Take-up unit” ( P.3-12) in machine settings.
• When performing printing or cutting of 700 mm or
more without using the taking-up device, evacuate
the takingup device to right and left. The quality of
the print and cut may become low because of the
impact when the front end of the media touches
the taking-up device.
To Next Page
Loading...
