2-25
2
2
2
2
2
Chapter 2 Basic Operation
6
Press to select “TOOL
REPLACE”, and press the key.
7
Press the key.
• The cutter unit moves to the left end of the
machine.
8
Rotate the knob to loosen the holder
presser.
9
Insert the pen adapter with the pen into the
tool holder.
• Make sure that the brim of the pen adapter is
rested on the tool holder.
• Set the adapter in such a way that the fixing screw
will not obstruct operation.
• Press the brim of the pen adapter with the holder
presser.
10
Turn the knob clockwise to fix the tool.
• Turn the knob of the tool holder clockwise, and
surely fix it.
• Instead of the ballpoint pen, you can attach the
refill that comes with it.
Follow the procedure below to attach the ballpoint
pen refill to the pen adapter, then put it into the tool
holder in the same way as in step 6.
(1) Insert a spring into the pen tip.
(2) While pressing the cap onto the spring,
attach it on the pen adapter.
• Rotate the cap to the direction indicated
with an arrow and attach it on the pen
adapter.
• When you replace the ballpoint pen (SPB-0726),
contact a distributor in your district or our office to
call for service
To Next Page
Loading...
